MMC Jumpers

Malaysian upgrade projects can use this configuration where its interface and fiber map align with both the installed cabling and the new hardware. MMC jumpers come with short, factory-completed connections between compact high-density multi-fiber interfaces. This category includes MMC-to-MMC cords for consistent VSFF channels and MMC-to-MTP versions for transitions to established MTP infrastructure, with sixteen or twenty-four fibers in OM4 or OS2.

Choose by interface before choosing by color

Start with the mating connector at every end, then determine gender, guide pins, fiber count and polish. MMC-to-MTP cords solve a form-factor transition but do not change gender or automatically intended polarity. The 24-fiber APC-to-UPC model is more specifically distinct from its APC-to-APC counterpart and should be ordered only when the channel requires that combination.

OS2 and OM4 serve different channel designs

OS2 jumpers use single-mode G.657.A1 glass and are specified at 1310/1550nm. OM4 versions use bend-insensitive multimode fiber at 850/1300nm. Connector return-loss ratings also differ by model. Match the fiber to the active optics and document each mated pair in the channel loss calculation instead of treating all short jumpers as equivalent.

Length and installation planning

The standard jumper lengths listed on this version pages are 1m (3ft), 2m (7ft) and 3m (10ft), with made-to-order meter and foot lengths available. Select a route that avoids the two tension and excess coils. Observe the specified bend radius, inspect each ferrule and determine jumper polarity against the full link before putting it into service.

Ordering and Factory Support

Factory configuration for this category can include length, end labels, connector polarity and gender after the full link has been reviewed. Come with quantities and the intended fitting or test plan with the order. Standard and project-specific products should be checked against the specification list on arrival, with labels and configuration records retained for maintenance. For Malaysian upgrades, our team can compare the requested build with the existing environment before production begins.

Product Selection

MMC-16 to MMC-16 APC Jumper, 16 Fibers, OS2
MMC Female to MMC Female, OS2 9/125μm, 16 Fibers.

MMC-16 to MMC-16 APC Jumper, 16 Fibers, OM4
MMC Female to MMC Female, OM4 50/125μm, 16 Fibers.

MMC-16 to MTP-16 APC Jumper, 16 Fibers, OS2
MMC Female to MTP® Female, OS2 9/125μm, 16 Fibers.

MMC-16 to MTP-16 APC Jumper, 16 Fibers, OM4
MMC Female to MTP® Female, OM4 50/125μm, 16 Fibers.

MMC-24 APC to MTP-24 UPC Jumper, 24 Fibers, OM4
MMC Female to MTP® Female, OM4 50/125μm, 24 Fibers.