MTP-8 APC to LC UPC Uniboot Trunk Cable, Female, 32 Fibers, OS2, Type B

This 32 Fibers (Base-8) MTP® Elite Female trunk assembly is built for backbone cabling between racks, rows and distribution frames. OS2 9/125μm fiber, Plenum (OFNP) jacket and factory installed pulling protection make it a one-pull replacement for hours of field termination work.

Standard lengths are 1m (3ft), 3m (10ft), 5m (16ft), 7m (23ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft), 30m (98ft) and 40m (131ft). Because we are the manufacturer, any other length between or beyond these steps can be produced on request, with your choice of jacket color, labeling and packaging.

Product Highlights

• MTP® Elite Female (Non-Pinned) to LC Duplex Uniboot, 32 Fibers (Base-8)
• OS2 9/125μm, G.657.A1
• Insertion loss ≤0.35dB, return loss ≥65dB
• Type B polarity
• 5.5-5.6mm Plenum (OFNP) round cable
• Minimum bend radius 10mm
• Ten standard lengths from 1m (3ft) to 40m (131ft), custom lengths built to order

Typical uses include backbone links between the main distribution area and equipment rows, vertical risers between floors, and inter-cabinet trunks in large data halls. The 32 Fibers (Base-8) construction concentrates the equivalent of many duplex jumpers into a single assembly, which is exactly what high density spine and leaf cabling needs. Pre-termination cuts installation time dramatically compared with field splicing.

The trunk uses a double jacket design: a rugged outer sheath protects the whole bundle, while each breakout leg keeps its own jacket and numbering. Base-8 and Base-12 constructions are available depending on the fiber count. Polarity follows the Type shown in the table, and pulling eyes or mesh grips can be fitted for installation.

Ordering is simple: send us HD-32FMTPLCSMF and your required lengths and quantities, and we return a factory quote the same working day. The 1m (3ft) version is the standard model; Small trial orders are welcome before you commit to a full project rollout.

Every cable is protected with dust caps and individual packaging before being boxed for shipment. Batch test reports and your own part number labels can be included in each bag.

Our test routine covers insertion loss, return loss and ferrule end face inspection on every assembly. Because testing is done in-house, custom variants receive exactly the same verification as standard models.

Standard configurations normally ship within a few working days by DHL, UPS, FedEx, TNT or EMS. For project quantities we arrange air or sea freight, and we can ship on your own courier account or deliver to your appointed forwarder.