MTP-8 to MTP-8 APC Trunk Cable, Male, 32 Fibers, OS2, Type B

High fiber count MTP® Elite Male trunk cable with 24 Fibers (Base-8), OS2 9/125μm and Plenum (OFNP) jacket. The double jacket construction protects the breakout legs during installation, and every leg is labeled and tested before the cable leaves our factory.

Standard lengths are 1m (3ft), 3m (10ft), 5m (16ft), 7m (23ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft), 30m (98ft) and 40m (131ft). Because we are the manufacturer, any other length between or beyond these steps can be produced on request, with your choice of jacket color, labeling and packaging.

Product Highlights

• MTP® Elite Male (Pinned) to MTP® Elite Male (Pinned), 24 Fibers (Base-8)
• OS2 9/125μm, G.657.A1
• Insertion loss ≤0.35dB (0.15dB Typ.), return loss ≥65dB
• Type B polarity
• 5.5-5.6mm Plenum (OFNP) round cable
• Minimum bend radius 10mm
• Ten standard lengths from 1m (3ft) to 40m (131ft), custom lengths built to order

Install this trunk wherever many fibers must move between two termination points at once. A 24-fiber MPO interface is the standard for 100GBASE-SR10 CFP, CFP2 and CPAK modules, and is equally at home in structured trunking between panels. The assembly is shipped on a reel or coil with pulling protection, ready for a single pull through trays and conduits.

Inside the outer jacket, the fibers are grouped into sub-units that fan out to individually labeled connectors. This protects the fibers during pulling and keeps the breakout area compact at the panel. Type A, B and C polarity and male or female connectors are built to your panel schedule.

Please reference 32FMTPSMF in your enquiry. The 1m (3ft) version is the standard model; Our sales team can also advise on polarity, gender and jacket choices if your project documentation is not final yet.

Our engineering team handles custom MPO/MTP assemblies daily. If the standard configuration does not match your link design, send us the requirement and we will build exactly what your network needs at factory-direct cost.

Our test routine covers insertion loss, return loss and ferrule end face inspection on every assembly. Because testing is done in-house, custom variants receive exactly the same verification as standard models.

Standard configurations normally ship within a few working days by DHL, UPS, FedEx, TNT or EMS. For project quantities we arrange air or sea freight, and we can ship on your own courier account or deliver to your appointed forwarder.