Customized MTP Breakout Cable, 16F, Crossover, OM4

This MTP®-16 APC with Offset Key breakout cable splits a high density multi-fiber interface into smaller legs, so one port can feed several lower speed links. OM4 50/125μm fiber and Plenum (OFNP)/LSZH jacket with Customized MTP Breakout Cable, 16F, Crossover, OM4 make it a tidy alternative to cassette based fan-out.

Available lengths are 1m (3ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft) and 30m (98ft). We can also produce any intermediate or longer length to order, with your choice of labeling and packaging.

Product Highlights

• MTP®-16 APC with Offset Key to MTP®-8 UPC,
• OM4 50/125μm, bend insensitive fiber
• Insertion loss ≤0.35dB, return loss ≥27/45dB (UPC/APC)
• Crossover polarity
• 3.0mm Plenum (OFNP)/LSZH round cable
• Minimum bend radius 7.5mm
• Stock lengths from 1m (3ft) to 30m (98ft), custom lengths on request

This breakout is used wherever one multi-fiber interface must serve several devices. The factory controlled fan-out keeps each leg at the right length and polarity, avoiding the tangle of separate patch cords.

The fan-out point is factory molded and strain relieved, with each breakout leg built to the length shown in the specification table. Wiring follows the polarity scheme listed, so the lane order at the far end matches the transceiver requirements without on-site re-termination.

Ordering is simple: send us 16FMTPOM4 and your required lengths and quantities, and we return a factory quote the same working day. Small trial orders are welcome before you commit to a full project rollout.

Every MPO/MTP assembly leaving our factory is 100% tested for insertion loss and return loss, with end face geometry checks on the multi-fiber ferrules. Controlled polishing keeps the loss budget stable across the whole batch, which matters when several mated pairs sit in one link.

We have manufactured fiber optic assemblies since 1995. MPO and MTP cabling is one of our core lines: fiber counts from 8 to 144, single mode and multimode, UPC and APC polish, trunk, jumper, harness and breakout formats. Send your drawing and we turn it into a ready to install assembly.

Standard configurations normally ship within a few working days by DHL, UPS, FedEx, TNT or EMS. For project quantities we arrange air or sea freight, and we can ship on your own courier account or deliver to your appointed forwarder.