Customized MTP-12 Armored Trunk Cable, 12-144F, OS2

This 12-144 Fibers (Base-12) MTP® Elite Female/Male trunk assembly is built for backbone cabling between racks, rows and distribution frames. OS2 9/125μm fiber, Plenum (OFNP)/LSZH jacket and factory installed pulling protection make it a one-pull replacement for hours of field termination work.

Available lengths are 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft) and 30m (98ft). We can also produce any intermediate or longer length to order, with your choice of labeling and packaging.

Product Highlights

• MTP® Elite Female/Male to MTP® Elite Female/Male, 12-144 Fibers (Base-12)
• OS2 9/125μm, G.657.A1
• Insertion loss ≤0.35dB (0.15dB Typ.), return loss ≥65dB
• Type A/Type B/Type C polarity
• Plenum (OFNP)/LSZH
• Minimum bend radius 10mm
• Stock lengths from 2m (7ft) to 30m (98ft), custom lengths on request

This trunk is designed for permanent backbone positions: between patch panels, from the core to aggregation rows, or between buildings on a campus. A 12-fiber MPO interface carries 8 active lanes for 40G SR4 and 100G SR4 links, leaving the remaining 4 fibers dark, exactly as the MSA wiring specifies. Every breakout leg is numbered, which simplifies documentation and troubleshooting.

The assembly is engineered for one-pull installation: reinforced trunk body, protected breakout point and sequential leg labels. We can supply pulling socks, different breakout lengths and custom leg numbering to match your rack elevation drawings.

Ordering is simple: send us AM-XXFMTPSMF and your required lengths and quantities, and we return a factory quote the same working day. Small trial orders are welcome before you commit to a full project rollout.

Products are packed in anti-static or PE bags with connector dust caps fitted, then boxed in sturdy export cartons. Custom labels, barcodes and carton markings are available on request.

Our engineering team handles custom MPO/MTP assemblies daily. If the standard configuration does not match your link design, send us the requirement and we will build exactly what your network needs at factory-direct cost.

Every MPO/MTP assembly leaving our factory is 100% tested for insertion loss and return loss, with end face geometry checks on the multi-fiber ferrules. Controlled polishing keeps the loss budget stable across the whole batch, which matters when several mated pairs sit in one link.