MTP-12 to MTP-12 APC Jumper, 12 Fibers, OS2, Type A

This 12 Fibers MTP® Elite Female jumper is factory terminated and fully tested in our own facility, built on OS2 9/125μm fiber with a Plenum (OFNP) jacket. It is designed for high density patching inside data center cabinets, where pre-terminated cabling saves hours of field splicing and keeps polarity under control from day one.

Standard lengths are 1m (3ft), 3m (10ft), 5m (16ft), 7m (23ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft), 30m (98ft) and 40m (131ft). Because we are the manufacturer, any other length between or beyond these steps can be produced on request, with your choice of jacket color, labeling and packaging.

Product Highlights

• MTP® Elite Female (Non-Pinned) to MTP® Elite Female (Non-Pinned), 12 Fibers
• OS2 9/125μm, G.657.A1
• Insertion loss ≤0.35dB (0.15dB Typ.), return loss ≥60dB
• Type A polarity (straight through)
• 3.0mm Plenum (OFNP) round cable
• Minimum bend radius 10mm
• Ten standard lengths from 1m (3ft) to 40m (131ft), custom lengths built to order

Use this jumper anywhere a short multi-fiber connection is needed: panel to equipment, cassette to cassette, or switch to switch within a row. A 12-fiber MPO interface carries 8 active lanes for 40G SR4 and 100G SR4 links, leaving the remaining 4 fibers dark, exactly as the MSA wiring specifies. Because it arrives polished and tested, the installer only needs to route and connect it.

This model is supplied in the polarity shown in the specification table. Type A maps fiber 1 to fiber 1 straight through, Type B reverses the array, and Type C swaps adjacent pairs. Female (pinless) connectors mate with panels and cassettes; male (pinned) versions are available for direct transceiver connection. Tell us your cabling scheme and we will build the matching variant.

Ordering is simple: send us 12FMTPSMF and your required lengths and quantities, and we return a factory quote the same working day. The 1m (3ft) version is the standard model; Small trial orders are welcome before you commit to a full project rollout.

Our test routine covers insertion loss, return loss and ferrule end face inspection on every assembly. Because testing is done in-house, custom variants receive exactly the same verification as standard models.

As a factory we can modify almost every detail of this product: length, jacket material and color, polarity, gender, breakout geometry, labeling and packaging. Non-standard variants are routine work for us, not a special project.

Most orders leave our facility within a few working days. Courier, air freight and sea freight are all available, and we are happy to hand goods to your nominated forwarder in China.