LC UPC to LC UPC Duplex Short Boot OM3 Fiber Patch Cable

Malaysian upgrade projects can use this configuration where its interface and fiber map align with both the installed cabling and the new hardware. This OM3 fiber patch cable carries a LC UPC interface on one end and a LC UPC interface on the other, factory terminated on OM3 glass and optically tested as a whole assembly. The duplex zipcord construction keeps the transmit and receive strands paired in one assembly for fast, error-free patching.

Product Highlights

• 60% Shorter in Boot Length, and 30% Reduction in Overall Connector Length
• Bend Insensitive Fiber with 7.5mm Min. Bend Radius
• Precision Zirconia Ferrule Connectors Ensure Low Loss
• Flame-Retardant Riser (OFNR) for Vertical and Floor-to-Floor Installations
• Color-Coded Cable Jacket for Easy Identification

Specifications

OM3 for existing multimode plants

This OM3 assembly matches the deployed base of OM3 channel cabling: 10G links to 300 meters and 40/100G SR4 links to 70 meters. When the permanent link is OM3, patching with OM3 keeps the channel specification homogeneous and the test reports clean.

Keeping multimode links healthy

Multimode links fail more often from contamination than from fiber damage. Each ferrule should be inspected and cleaned before joining the interfaces, and the dust caps ought to stay on until the moment of connection. These habits matter more than any specification on the datasheet.

Short boot connectors for tight spaces

The shortened boot shrinks the mating connector footprint behind the mounted panel, which matters in compact high-density frames where the bend space behind every port is measured in millimeters. The shorter lever arm also reduces the side load on the ferrule when the cord is dressed sharply to the side.

Length Options

Normal length options cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), with project-specific length available beyond the list. Specifying the measured route length keeps the slack out of the manager and the strain off the relevant connectors.

Quality Control and Testing

Each finished assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. The completed cable ships with dust caps on the two connectors and the test result available on request.

Ordering and Factory Support

Refer to this configuration by connector pair, fiber mode and length when seeking a quotation. For configurations outside the listed options, mixed connector families, jackets, labelling or project packing, send the need with the inquiry and the factory will determine the build before the product is built. For Malaysian upgrades, our team can compare the requested build with the existing environment before production begins.