
This MPO Female/Male with Offset Key harness fans one multi-fiber connector out to duplex LC legs, replacing a cassette and patch cords with a single factory tested assembly. OS2 9/125μm fiber, 16 Fibers (Base-16), Plenum (OFNP)/LSZH jacket.
Available lengths are 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft) and 30m (98ft). We can also produce any intermediate or longer length to order, with your choice of labeling and packaging.
| Part Number | 16FMPOXXSMF |
|---|---|
| Manufacturer | HT |
| Connector A | MPO Female/Male with Offset Key |
| Connector B | LC/SC/FC/ST |
| Fiber Mode | OS2 9/125μm |
| Wavelength | 1310/1550nm |
| Glass Fiber | G.657.A1 |
| Minimum Bend Radius | 10mm |
| Polish Type | APC to UPC/APC |
| Polarity | Straight Through/Crossover |
| Cable Jacket | Plenum (OFNP)/LSZH |
| Trunk Outside Diameter (OD) | 3.0mm |
| Breakout Outside Diameter (OD) | 2.0mm (Duplex), 2.0/0.9mm (Simplex) |
| Fiber Count | 16 Fibers (Base-16) |
| MPO Connector IL | ≤0.35dB |
| MPO Connector RL | ≥60dB |
| Standard Connectors IL | UPC≤0.2dB, APC≤0.3dB |
| Standard Connectors RL | UPC≥50dB, APC≥60dB |
| Attenuation at 1310nm | ≤0.35dB/km |
| Attenuation at 1550nm | ≤0.21dB/km |
| Operating Temperature | OFNP: -10 to 60°C (14 to 140°F)LSZH: -10 to 70°C (14 to 158°F) |
| Storage Temperature | OFNP: -10 to 70°C (14 to 158°F)LSZH: -20 to 70°C (-4 to 158°F) |
Install this harness between an MPO trunk or panel and LC based transceivers. The 16-fiber interface matches 400G SR8 optics, where all 16 fibers carry active transmit and receive lanes. The labeled duplex legs make it easy to land each pair on the correct port.
Every LC duplex leg is factory polished and tested individually, with return loss well above the multimode or single mode requirement. The fan-out is compact and strain relieved, and the leg numbering matches the polarity table for error-free patching.
Ordering is simple: send us 16FMPOXXSMF and your required lengths and quantities, and we return a factory quote the same working day. Small trial orders are welcome before you commit to a full project rollout.
Every cable is protected with dust caps and individual packaging before being boxed for shipment. Batch test reports and your own part number labels can be included in each bag.
Our test routine covers insertion loss, return loss and ferrule end face inspection on every assembly. Because testing is done in-house, custom variants receive exactly the same verification as standard models.
Our engineering team handles custom MPO/MTP assemblies daily. If the standard configuration does not match your link design, send us the requirement and we will build exactly what your network needs at factory-direct cost.