Customized Duplex Uniboot Fiber Patch Cable, LC UPC, OS2

Malaysian upgrade projects can use this configuration where its interface and fiber map align with both the installed cabling and the new hardware. This project-specific fiber patch cable is built to the exact configuration the project specifies: connector styles, polish, fiber mode, jacket and length are all chosen at order time and the finished product is factory terminated and optically tested before dispatch.

Product Highlights

• Offered in Riser (OFNR)/LSZH Flame-retardant Jacket with 1.6/2.0mm Cable Diameters
• Available in Standard/Flat Clip and Push Pull Tabs Connector Types
• Uniboot Design Allows One Cable to Carry Two Fibers to Reduce the Cable Bulk When Routing
• Optical Performance Test for Normal Network Connections
• Compliant to ANSI/TIA-568-D.3

Specifications

Built to the order

The project-specific program covers the combinations that stock lists cannot: mixed connector families, non-standard jackets, unusual lengths, labelling and packing to the project specification. The finished product is terminated and tested exactly like a stock product, with the configuration confirmed before the product is built.

Bend tolerance in real cabinets

Patch fields are rarely kind to fiber. Cords route through tight managers, sharp tray corners and crowded vertical channels. The bend-insensitive glass in the finished assembly tolerates a 10mm fiber bend radius, meaning that a hurried routing decision during a night maintenance window is not designed to turn into a measurable penalty on the link.

Where single-mode jumpers earn their place

Single-mode patching carries the links that leave the room: campus backbones, carrier handoffs, long runs between buildings and each wavelength-multiplexed service. The OS2 glass in the finished assembly is the same category used in the outside plant, meaning that this jumper assembly is not designed to become the weak point of the channel budget. At 1310 and 1550nm the attenuation stays a fraction of a decibel per kilometer, and the mating connector pair adds less than 0.3dB when the end faces are clean and seated.

Length Options

Normal length options cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 30m (98ft), with project-specific length available beyond the list. Specifying the measured route length keeps the slack out of the manager and the strain off the relevant connectors.

Quality Control and Testing

Each finished assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. The completed cable ships with dust caps on the two connectors and the test result available on request.

Ordering and Factory Support

Refer to this configuration by connector pair, fiber mode and length when seeking a quotation. For configurations outside the listed options, mixed connector families, jackets, labelling or project packing, send the need with the inquiry and the factory will determine the build before the product is built. For Malaysian upgrades, our team can compare the requested build with the existing environment before production begins.