Customized Duplex Fiber Patch Cable, LC/SC/FC/ST/LSH/MU/MTRJ, OS2

Malaysian upgrade projects can use this configuration where its interface and fiber map align with both the installed cabling and the new hardware. This project-specific fiber patch cable is built to the exact configuration the project specifies: connector styles, polish, fiber mode, jacket and length are all chosen at order time and the finished product is factory terminated and optically tested before dispatch.

Product Highlights

• G.657.A1 Bend Insensitive Fiber Delivers Superior Low Loss and Bend Resistance
• Precision Zirconia Ferrule Connectors Ensure Low Loss
• Duplex Zipcord Construction Reduces Risk of Damage from Crimping
• Available in LC, SC, FC, ST, LSH, MU, and MTRJ Connectors
• Available in 1.2mm, 1.8mm, 2.0mm, and 3.0mm Cable Diameters

Specifications

Built to the order

The project-specific program covers the combinations that stock lists cannot: mixed connector families, non-standard jackets, unusual lengths, labelling and packing to the project specification. The finished product is terminated and tested exactly like a stock product, with the configuration confirmed before the product is built.

Where single-mode jumpers earn their place

Single-mode patching carries the links that leave the room: campus backbones, carrier handoffs, long runs between buildings and each wavelength-multiplexed service. The OS2 glass in the finished assembly is the same category used in the outside plant, meaning that this jumper assembly is not designed to become the weak point of the channel budget. At 1310 and 1550nm the attenuation stays a fraction of a decibel per kilometer, and the mating connector pair adds less than 0.3dB when the end faces are clean and seated.

Connector and polish choices in the single-mode plant

The OS2 interface on this jumper follows the polish discipline of the network it serves. Mixing polishes on a mated pair destroys the return loss and might damage the ferrules, meaning that the patch side must agree with the mounted panel side exactly. When the documentation is unclear, the boot color and the mating connector housing tell the truth: green for APC, blue or beige for UPC.

Length Options

Normal length options cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), with project-specific length available beyond the list. Specifying the measured route length keeps the slack out of the manager and the strain off the relevant connectors.

Quality Control and Testing

Each finished assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. The completed cable ships with dust caps on the two connectors and the test result available on request.

Ordering and Factory Support

Refer to this configuration by connector pair, fiber mode and length when seeking a quotation. For configurations outside the listed options, mixed connector families, jackets, labelling or project packing, send the need with the inquiry and the factory will determine the build before the product is built. For Malaysian upgrades, our team can compare the requested build with the existing environment before production begins.